Cabinet Vision One person, everything queued behind them.

One person understands the setup. They program, they detail, they solve whatever comes up, and everything queues behind them. When they are on holiday the queue grows, and when they leave it becomes a genuine problem.

Adding capacity is difficult because the knowledge is specific to your environment rather than to the software.

We work inside your existing Cabinet Vision setup,

following what is already configured rather than substituting our own approach.

Drawing production

to your conventions, under your title block.

Output from the same source,

so what goes to the floor and what goes to review describe the same parts.

Your conventions recorded once.

Captured in a Standards Record on the first project and applied consistently after that, which is what makes capacity additive rather than a supervision burden.

We do not configure or develop your catalog.

Whatever your setup contains is what the work is built on.

We do not set up machine integration.

Configuration that connects the software to a specific machine is not part of this service.

We do not write post-processors or G-code.

That stays with your programmer or your machine integrator, permanently.

We are not a Cabinet Vision reseller, partner or implementation consultancy.

Send a set from Cabinet Vision →

Everything queueing behind one person.

The most common failure, and it is a capacity problem rather than a software one.

A setup altered by an outside team.

Changes made to suit someone else's working preference, inherited later by whoever takes over.

Parameters assumed.

Output produced against material sizes and machine settings nobody confirmed, which looks authoritative and cuts wrong.

Drawings and machine output diverging.

Produced separately, describing subtly different parts.